Sherwood R-865 - Manual (Page 45)

ENGLISH
45
Select the desired input source to enter its
label.
1
Press the LABEL button to enter the label
input mode.
Example ) When selecting VIDEO 1.
2
Select the character on the flickering digit.
3
Confirm your selection.
4
Repeat the above steps and to enter
the desired characters on the rest of the
digits.
5
Memorize the desired label.
6
Entering a label
Select the desired input source to be
rectified or cleared.
1
Repeat the steps ~ in “Entering a
label” procedure.
2
Correcting or clearing a label
• Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols:
• This function can be operated on the input sources
except TUNER, TAPE MONITOR and 8 CH
DIRECT.
• Then the next digit will flicker.
• On up to 9 digits, the desired characters can be entered.
Note: If any of INPUT SELECTOR buttons is
pressed while entering a label, the label input
mode will be canceled.
• To clear a label, make a blank on each digit and
memorize it, then the label is cleared and its factory
input source will be displayed.
• If the LABEL button is pressed for more than 3
seconds, blanks will be made on all the digits at
once.
or
or