Samsung SNB-3000(P) - Manual (Page 36)

_ network connection and setup
network connection and setup
IPv4 Scans for cameras with the IPv4 setting.
IPv6 Scans for cameras with the IPv6 setting.
Search
Scans for cameras that are currently connected to the network.
However, this button will be grayed out if neither IPv4 nor IPv6 is checked.
Auto Set <IP Installer> will automatically configure the network settings for you.
Manual Set You should configure the network settings manually.
Exit Exits the IP Installer program.
STATIC Ip SeTUp
manual Network Setup
Run <Ip Installer.exe> to display the camera search list.
At the initial startup, both [Auto Set] and [manual Set] will be grayed out.
For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not
support this function.
Select a camera in the search list.
Find the MAC (Ethernet) address
labeled on the rear of the camera.
Both the [Auto Set] and [manual Set]
buttons will be activated.
Click [manual Set].
The MANUAL SET dialog appears.
The default values of <Ip Address>,
<Subnet mask>, <Gateway>, and <hTTp port> of the camera will be displayed.
The default <pASSWoRd> is 4321.
In the <AddReSS> pane, provide the
necessary information.
MAC (Ethernet) Address : The MAC
(Ethernet) address of the applicable
camera will be set automatically so you
don't need to input it manually.
M 
1.
2.
3.