Samsung SNB-3000(P) - Manual (Page 51)

English _1
●
Se
TU
p S
CR
ee
N
Target bitrate : Transfers video signal at a specified bit rate.
Compression : Adjust the compression rate from 5 through 100 by 5.
Encode priority : Set the video transfer method to Frame rate or Quality.
GOP* size : Select a GOP size between 5 and 15.
Deblock : This will soften the edges between macro blocks.
De-Interlace : You can reduce the grid noise by using the de-interlacing function.
Only available if MPEG4 resolution is set to 4CIF.
If the WDR is set to <OFF> or the MPEG4 resolution is not 4CIF, you cannot enable the
MPEG4 CODEC’s de-interlacing
Profile : Select Baseline or Main for the H.264 profiling method.
Entropy coding* : Reduces the compression loss due to encoding.
If you set the profile to Baseline, the entropy coding is available only for CAVLC*; if you set it
to MAIN, the entropy coding is available for both CAVLC* and CABAC*.
Motion estimation : Estimates the movement of pixels by determining the motion vector.
Input gain : You can set the audio input gain from 0 to 10.
Output gain : You can set the audio output gain from 0 to 10.
If the audio input gain is set to 0, no sound is heard.
When done, click [Apply].
Your settings will be saved.
To configure the Ip settings
Select <Basic> - <Ip>.
The IP setup window appears.
IP configuration : Set the IP and port
settings for the camera.
IP type : Select one from <Static
Ip>, <dynamic Ip>, and <pppoe
Ip>.
If you select <PPPoE IP>, you can
provide the optional ADSL IP and
password. However, the multicast items
(multicast address, port, TTL) for VNP
and RTP will disappear.






J



J 



J 
2.
1.

-
