Samsung SNB-3000(P) - Manual (Page 61)

English _1
●
Se
TU
p S
CR
ee
N
To setup the record
Click <event> - <Record setup>.
The Record setup window appears.
To complete the setting, click the
[Apply] button.
The settings are saved.
SD card : Enables you to verify data
saved on the SD memory card and
format the memory card itself. It
is possible to set to automatically delete movie clips recorded before a certain
period of time (e.g. 1 week, 1 month, or 1 year).
Options : Determine whether or not you wish to receive Email notification of
insufficient capacity warnings.
To set an alarm image
You can configure to send message via FTP/E-mail (SMTP) or to save recording into the
SD memory card.
Select a transfer method when an event occurs or the schedule transfer function is activated.
Select <event> - <Alarm image>.
The Alarm Image setup window
appears.
Transfer mode : You can select
alarm message notification method
among FTP/E-mail transfer and SD
Card recording.
FTP transfer : The image is sent to
the specified FTP address.
E-mail transfer : The image is sent to the specified email address.
SD Card Record : Saves images into the SD memory card.
If an SD memory card is not inserted, the corresponding button will be disabled.
In this case, insert the SD memory card into the slot and refresh to enable the button.
If the SD memory card is ejected while the button is checked, the camera automatically
restarts.
Transferred image naming setup : You can set the file name of an alarm image
to be sent when an alarm is triggered or during the scheduled transfer.
pre/post alarm image : You can set to save the pre or post alarm image.
Number of image : The frame rate per second can be one among 1, 2, 3, and 5.
Pre-alarm duration : The pre alarm duration can be one among 5 seconds, 10
seconds, 15 seconds, and 30 seconds. You can send a pre-alarm image of up
to 30 seconds before the alarm is triggered.
(The max time differs, depending on the frame rate)
1.
2.


1.

-
-
-
M 
J 


-
-