Samsung SNB-3000(P) - Manual (Page 37)

English _
●
Ne
TW
oR
k Co
NN
eCTI
oN
AN
d Se
TU
p
If using an Ip router :
IP Address : Enter an address falling in
the IP range provided by the IP router.
ex) 192.168.1.2~254,
192.168.0.2~254,
192.168.XXX.2~254
Subnet Mask : The <Subnet mask> of
the IP router will be the <Subnet mask>
of the camera.
Gateway : The <Local Ip Address> of
the IP router will be the <Gateway> of the camera.
If not using an Ip router :
For setting <Ip Address>, <Subnet mask>, and <Gateway>, contact your network
administrator.
The values of Device, TCP, UDP, Upload, and Multicast ports can not be changed manually, and
will be adjusted according to the HTTP port value.
In the <poRT> pane, provide
necessary information.
HTTP Port : Used to access the
camera using the Internet browser,
defaulted to 80. Use the spin button
to change the HTTP Port value. The
start value of the port is 80, and
increases or decreases by 6 like
10000, 10006, 10012.
Device Port : Used to control the video signal transfer, defaulted to 60001(TCP).
TCP Port : Video signal transfer port using TCP protocols, defaulted to
60002(TCP).
UDP Port : Video signal transfer port using the UDP Unicast method, defaulted to
60003(UDP).
Upload Port : Used to upgrade the software firmware, defaulted to 60004(TCP).
Multicast Port : Video signal transfer port using the UDP Multicast method,
defaulted to 60005(UDP).
Enter the password.
This is the login password for the "admin" user who accesses the camera.
The default password is "4321".
Click [ok].
Manual network setup will be completed.
When the manual setup including <Ip> is completed, the camera will restart.



M 
4.






5.
6.
7.