Sony HDW-M2100 - Manual (Page 57)

6-8
Chapter 6 Tele-File
Chapter 6
Tele-File
To add and delete clips
To add clips
1
Rotate the MULTI CONTROL knob to move the
“*” cursor to the position where you want to insert
the clip.
2
Press the F2 (SELECT) button.
The unit enters clip data modification mode.
3
Press the F5 (INS LN) button.
A confirmation message “INSERT CLIP OK?”
appears.
4
Press the F2 (OK) button.
The clip is added at the position to which you
moved the cursor in step 1.
To delete clips
1
Select the clip to delete.
2
Press the F2 (SELECT) button.
The unit enters clip data modification mode.
3
Press the F4 (DEL LN) button.
A confirmation message “DELETE THIS CLIP
OK?” appears.
4
Press the F2 (OK) button.
The clip selected in step 1 is deleted.
To set time code data
Proceed as follows to make or change settings for cue
point, IN point, and OUT point data.
1
Select a clip.
2
Select cue point, IN point, or OUT point.
3
Press the F2 (SELECT) button.
The unit enters clip data modification mode.
4
Press the F2 (MODIFY) button.
The two most significant digits begin to flash, and
the data can be set or modified.
5
Press the F3 ( T) or F4 (t) button until the digit
that you want to set starts flashing.
6
Rotate the MULTI CONTROL knob to make the
setting.
To display the offset from the previous setting
value
The offset is displayed as long as you hold down
the F2 (OFFSET) button.
7
Repeat steps 5 and 6 until you have set all the
required digits.
8
Press the F5 (SET) button.
The setting is confirmed and the unit returns to clip
data display mode.
To cancel the setting or modification and return
to clip data display mode
Press the F1 (CANCEL) button.
6-3 Tele-File Menu