2 function menu item list, Page 4 page 5 – Sony HDW-M2100 User Manual
Page 70
Chapter 8
Function Menu
8-6
Chapter 8
Function Menu
Page 4
Page 5
Item
Setting
F1 (CAPSTN)
Selects the number of fields for capstan lock in playback.
In 59.94i, 29.97PsF mode
2F: The capstan servo locks in units of 2 fields.
When playing back a tape that was recorded with composite source signals, a vertical shift in the video
(H shift) occurs. (When setup menu item 712 is set to ON.)
4F: The capstan servo locks in units of 4 fields.
Even when playing back a tape that was recorded with composite source signals, no vertical shift in the
video (H shift) occurs. You should set this menu item to this setting when continuity in video phase
across edit points is required for composite signal playback or when carrying out A/B roll editing.
In 50i, 25PsF mode
2F: The capstan servo locks in units of 2 fields.
When playing back a tape that was recorded with composite source signals, a vertical shift in the video
(H shift) occurs. (When setup menu item 712 is set to ON.)
4F: The capstan servo locks in units of 4 fields.
When playing back a tape that was recorded with composite source signals, a vertical shift in the video
(H shift) occurs. (When setup menu item 712 is set to ON.)
8F: The capstan servo locks in units of 8 fields.
Even when playing back a tape that was recorded with composite source signals, no vertical shift in the
video (H shift) occurs. You should set this menu item to this setting when continuity in video phase
across edit points is required for composite signal playback or when carrying out A/B roll editing.
Note
The setting is automatically fixed at 2F when operating in 24PsF or 23.98PsF mode, and this cannot be
changed.
F3 (DOLBY)
When using oxide tapes, specifies whether or not to use the Dolby type C low-frequency noise reduction
(NR) system.
NR ON : Use the Dolby NR system when playing back analog Betacam oxide tapes.
NR OFF : Do not use the Dolby NR system when playing back analog Betacam oxide tapes.
F4 (CHARA)
F5 (RECINH)
Specifies whether or not to inhibit recording shot marks to tape.
ON: Inhibit recording to tape.
OFF: Do not inhibit recording to tape.
Specifies whether or not to superimpose time code, menu settings, error messages, and so on over the
video signals output to the HDSDI OUTPUT3(SUPER) connector, SDI OUTPUT3(SUPER) connector and
COMPOSITE VIDEO OUTPUT3(SUPER) connector.
ON: Superimpose.
OFF: Do not superimpose.
Item
Setting
F1 (TELE-F)
Displays the Tele-File menu.
For details of the Tele-File menu, see Section 6-3 “Tele-File Menu” (page 6-3).
F2 (UMID)
Displays UMID information during playback.
For details of UMID, see Chapter 7.
8-2 Function Menu Item List