1-3 dynamic motion control (dmc) playback, 1 playback – Sony HDW-M2100 User Manual

Page 39

Advertising
background image

Chapter 4

Playback

4-6

Chapter 4

Playback

4-1 Playback

Storing a varying playback speed in
memory

To store the playback speed for DMC playback, use
the following procedure.

1

Press the DMC EDIT button, turning it on.

2

While playing back the recorded tape, press the
ENTRY button and one of the following buttons
simultaneously, to set the start and end points.
• On-air start point: PLAY IN button
• Speed variation start point: STUNT IN button
• Speed variation end point: STUNT OUT button
• On-air end point: PLAY OUT button

Each press turns the corresponding button on.

Waiting for the on-air cue
before starting DMC
playback

On-air start point Preroll point

Speed variation start point

Speed variation end point

On-air end point

Stop

Press the CUE/PLAY button.

Press the CUE/PLAY button
again at the on-air cue.

Normal speed
playback

DMC playback

Normal speed playback

Stop

Starting DMC playback
immediately after preroll

Normal speed
playback

DMC playback

Normal speed playback

Press the LEARN button.

Z

2

5

1,4

7 3 3,4,6

4-1-3 Dynamic Motion Control (DMC) Playback

Overview

DMC playback allows you to vary the playback speed
for a certain section of a tape, in variable speed mode
and store the varying speed in memory for later
playback at the same varying speed.
For example, during a live broadcast of a sporting
event you can set the start and end points of highlights

while recording, and then provide immediate DMC
playback of those highlights.

During DMC playback the tape moves as shown in the
following figure.

Advertising
This manual is related to the following products: