Sony MZ-N10 - Manual (Page 25)

25
Notes
• “TOC Edit” flashes while data of the
recording (the track’s start and end points,
etc.) is being recorded. Do not move or jog the
recorder or disconnect the power source while
the indication is flashing in the display.
• If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected) during
a recording or editing operation, or while
“TOC Edit” appears in the display, then it will
not be possible to open the lid until power is
restored.
• Note the following when recording from a
portable CD player:
—Some portable CD players may not be
capable of digital out when the AC power
adaptor is disconnected. If this is the case,
connect the AC power adaptor to the
portable CD player and use it on AC power
as the power source.
—On some portable CD players, optical
output may not be possible when using an
anti-skip function (e.g., ESP* or G-
PROTECTION). If this is the case, turn off
the anti-skip function.
∗
Electronic Shock Protection
z
• The recording level is adjusted automatically.
To adjust the level manually, see “Adjusting
the recording level manually” (page 34).
• You can monitor the sound during recording.
Connect the headphones/earphones with
remote control to i/LINE OUT and adjust the
volume by turning the control on the remote
control (pressing the control key towards VOL
+ or – on the recorder). This does not affect
the recording level.