Sony MZ-N10 - Manual (Page 41)

41
6
Slide the jog lever repeatedly to select
the elapsed time.
Each time you slide the jog lever, the
elapsed time setting (TIME :)
changes by 1 minute, within a range
of 1 to 99 minutes.
7
Press the jog lever to enter the setting.
The time remaining until the alarm is
shown in the display while the
recorder is stopped.
To cancel the procedure
Press x for 2 seconds or more.
To return to the preceding
setting
Press x.
To check the time remaining
until the alarm
Stop playback. The remaining time will
appear in the display after a short while.
Do steps 1 to 6 again to display the
remaining time during play or play-pause.
To cancel the alarm setting
Select “OFF” in step 4.
To stop the alarm
Press any button.
z
• If you end the procedure after step 4, the
previous alarm setting is automatically used.
• After sounding for one minute, the alarm will
automatically stop and the alarm setting will
be canceled. If the alarm sounds during stop
mode, then the power will automatically turn
off 10 seconds after the alarm stops. If the
alarm stops while an MD is playing, the
playback will continue uninterrupted.
Notes
• The settings will be lost when you start
recording.
• The timer will begin counting down from the
moment you select “ON” in step
4 . The
recorder will begin counting down again from
the moment you change the elapsed time in
step 6.
For the recorder operation, see
page 72.