Sony MZ-N10 - Manual (Page 62)

62
Setting the clock to stamp the
recorded time
To stamp the date and time on the MD
when you record, you first need to set the
clock. Once you set the clock, the
recorder will include a time stamp each
time you record something. The recording
date is not recorded for tracks that are
checked out from your computer.
This function can be set with the recorder
only.
1
When the recorder is stopped, enter
the menu and select “OPTION” -
“CLOCK SET”.
The digits of the year flash.
2
Change the current year by turning
the jog dial, and then press the jog
dial.
The digit of the month flashes.
3
Repeat step 2 to enter the current
month, date, hour, and minute.
When you press the jog dial to enter
the minute, the clock starts operating.
If you make a mistake while
setting the clock
Press the control key towards . to go
back to the wrongly entered item, and
then enter the correct value. You can skip
a step by pressing the control key towards
>.
To display the current time
• On the recorder
While the recorder is stopped or
recording, enter the menu, and select
“DISPLAY” - “Clock”.
• On the remote control
While the recorder is stopped or
recording, press DISPLAY repeatedly.
To display the time in the 24-
hour system
While setting the clock, press T MARK.
To display the time in the 12-hour system,
press T MARK again.
To maintain the correct time
Once you set the clock, it will keep correct time
as long as the recorder is connected to a power
source, such as the charged built-in
rechargeable battery, alkaline dry battery, or AC
power adaptor. However, if the built-in
rechargeable battery becomes drained or the
BUILT-IN BATTERY switch is set to OFF, the
clock setting will change back to the factory
setting. If this happens, set the clock again.
Notes
• Make sure the time is correctly set if you want
the time stamp to be accurately recorded for
an important recording.
• Under normal conditions, the clock may vary
by about plus or minus 3 minutes per month.
Turning off the beep sound
You can turn off/on the beep sound on the
recorder and the remote control.
1
Enter the menu and select “OPTION”
- “BEEP”.
2
Select “BEEP OFF”.
To turn on the beep sound
Select “BEEP ON”.