Recording from a microphone, To select microphone sensitivity, 32 recording from a microphone – Sony MZ-N10 User Manual
Page 32
32
Recording from a
microphone
1
Connect the stereo microphone to the
MIC (PLUG IN POWER) jack.
The recorder changes to microphone
input automatically.
2
Press and slide zREC to start
recording.
To select microphone
sensitivity
1
While the recorder is recording or
stopped, press the jog dial.
2
Turn the jog dial until “REC SET”
appears in the display, and then press
the jog dial.
3
Turn the jog dial until “MIC SENS”
appears in the display, and then press
the jog dial.
4
Turn the jog dial until “SENS HIGH”
or “SENS LOW” appears in the
display, and then press the jog dial to
enter the selection.
SENS HIGH
: When recording a soft
sound or a sound with a normal
volume.
SENS LOW
: When recording a loud
sound or a sound at close range.
z
When using a plug-in power-type microphone,
the microphone can be operated even when its
power switch is turned off since power is
supplied from the recorder itself.
Notes
•
The recorder automatically switches input in
the following order; optical input, microphone
input, and analog input. You cannot record
through the microphone while an optical cable
is connected to the LINE IN (OPT) jack.
•
The microphone may pick up the operating
sound of the recorder itself. Use the
microphone away from the recorder in such
cases. Please note that the sound of recorder
operations may be picked up if the
microphone that you use has a short
connector.
•
Only the left-channel sound is recorded when
a monaural microphone is used.
to MIC (PLUG IN POWER)
Stereo
microphone*
z
REC
Jog dial
∗