Sony MZ-N10 - Manual (Page 90)

90
Messages
If the following error messages flash in the display window, check the chart below.
Error message Meaning/Remedy
FULL • You tried to set a 21st bookmark.
, You can set only up to 20 bookmarks. Keep the number of
bookmarks within 20.
AVLS • AVLS is set to “AVLS ON” and so the volume cannot rise higher.
, Set AVLS to “AVLS OFF” (page 68).
BLANKDISC • An MD with no recording on it is inserted.
BUSY • You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take a
few minutes).
CannotCHG • You tried to charge the battery at a place with a temperature
outside the specified range for the recorder.
, Charge the battery at a temperature of 0
°
C (+32
°
F) to +40
°
C
(+104
°
F).
Charging • The internal battery is being charged.
DISC FULL • The remaining recording time on the disc is 12 seconds (SP
stereo), 24 seconds (LP2 stereo or monaural), 36 seconds (LP4
stereo), or less.
, Replace the disc.
ERROR • There is an internal malfunction in the system.
, Restart the operation by doing steps 1 to 3 on page 89. If the
message appears again, please consult your nearest Sony
dealer.
GroupFULL • You tried to create a 100th group.
, You can create only up to 99 groups on a disc. Keep the group
number within 99.
Hi DC in • Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder (page 20) .
LINE OUT • You pressed VOL+, – while the “AUDIO OUT” parameter was set
to “LINE OUT”.
, Use the jog dial to set the “AUDIO OUT” parameter to
“HeadPhone”.