Sanyo CH0951 User Manual
Page 11
11
Cover
plate
Terminal
plate
Electrical
component
box
Earth plate
Fig. 25b
Cover
plate
Electrical
component box
Fig. 25c
Cover
plate
Terminal
plate
Electrical
Component
box
Earth plate
Fig. 25d
Cover
plate
Electrical
component box
Fig. 25a
Fig. 26a
Earth
Plate
c)
Remove the screws to open the cover plate secur-
ing the electrical component box. (Figs. 25a, 25b,
25c and 25d)
d)
Insert the wrapped tubing into the hole in the wall.
e)
Hang the indoor unit on the rear panel.
f)
Using a Phillips screwdriver, take out the screws on
the earth plate. (Fig. 26a KHS09, 12 models only)
Remove the earth plate.
g)
Remove the lock nut from the conduit connector.
Insert the conduit connector through the opening
from the underside of the electrical component box.
After insertion, Fit the screw at the top of the con-
duit connector into the cut-out. (Fig. 26b). Position
the earth plate over the conduit connector, allowing
the connector and wires to extend through the hole
in the plate. Next, attach the conduit connector to
the earth plate by replacing and tightening the lock
nut (Figs. 26c and 26d). Then re-attach the earth
plate to the electrical component box with the 2
screws.
h)
Give some play to the inter-unit wiring from the out-
door unit to the corresponding terminals on the termi-
nal base. (See Wiring System Diagram on page 10.)
i)
Fix cover plate and cover plate and back into posi-
tion with their screws.
When closing the air intake grille, press on both corners
and the center. (Fig. 27)
NOTE
WARNING
●
Be sure to refer to the Wiring System Diagram
label inside the electrical component box and
carry out the correct field wiring. Wrong wiring
can cause the unit to misoperate or result in a fire
hazard.
●
Check local electrical codes and any specified
wiring instructions or limitations.
Fig. 27
Fig. 26c
Inter-unit
(Power line)
wiring
Inter-unit
(Control line)
wiring
Earth
Plate
Lock nut
Fig. 26d
Lock
nut
Top of conduit
t
Inter-unit
Control line
Wiring
Earth
plate
Power line
Fig. 26b
Top of conduit
connector
Screw
Screw
hole
KHS0951, KHS1251
KHS0951, KHS1251
KHS1852
KHS1852
KHS1852
KHS0951, KHS1251
KHS1852
KHS0951, KHS1251
01-385 AirCon 12/11/01 4:42 PM Page 11