Sanyo CH0951 - Manual (Page 3)

3
1. General
This booklet briefly outlines where and how to install the
air conditioning system. Please read over the entire set
of instructions for the indoor and outdoor units and
make sure all accessory parts listed are with the system
before beginning.
1-1. Tools Required for Installation (not supplied)
1. Standard screwdriver
2. Phillips head screwdriver
3. Knife or wire stripper
4. Tape measure
5. Carpenter’s level
6. Sabre saw or key hole saw
7. Hacksaw
8. Core bits
9. Hammer
10. Drill
11. Tube cutter
12. Tube flaring tool
13. Torque wrench
14. Adjustable wrench
15. Reamer (for deburring)
1-2. Accessories Supplied with Unit
Table 1
1-3. Optional Copper Tubing Kit
Copper tubing for connecting the outdoor unit to the
indoor unit is available in kits which contain the narrow
and wide tubing, fittings and insulation. Consult your
nearest sales outlet or A/C workshop.
1-4. Type of Copper Tube and Insulation Material
If you wish to purchase these materials separately from
a local source, you will need:
1. Deoxidized annealed copper tube for refrigerant
tubing as detailed in Table 2.
When cutting tubing, add approximately 12" to 16"
(30 cm to 40 cm) to each tube length to reduce
vibration between the air conditioning units.
Table 2
2. Foamed polyethylene insulation for the specified
O.D. copper tubes as required to precise length of
tubing. Wall thickness of the insulation should be
not less than 0.3 in. (8 mm).
1-5. Field Wiring
Use insulated copper wire for field wiring. Wire size
varies with the total length of wiring. Refer to 3-6. Wiring
Instructions for details.
Parts Figure Q’ty Parts Figure Q’ty
Rawl plug 12 12
Tapping
screw
Truss-head
Phillips
5/32
Ч 5/8" (4 Ч 16 mm)
2 1
1
AAA alkaline
battery
1
1
Parts Figure Q’ty
Remote
control unit
Drain hose
adapter
Hex
wrench
*
Remote
control
holder
CAUTION
Check local electrical codes
and regulations before
obtaining wire. Also, check
any specified instructions or
limitations.
Narrow Tube Wide Tube
Model
Outer Dia. Thickness Outer Dia. Thickness
6.35 mm (1/4") 0.8 mm (0.0314") 9.52 mm (3/8") 0.8 mm (0.0314") CH0951
6.35 mm (1/4") 0.8 mm (0.0314") 12.7 mm (1/2") 0.8 mm (0.0314") CH1251
6.35 mm (1/4") 0.8 mm (0.0314") 15.88 mm (5/8") 1.0 mm (0.0394") CH1852
* Packed in the outdoor unit.
01-385 AirCon 12/11/01 4:41 PM Page 3