Sanyo CH0951 - Manual (Page 6)

6
Set screw only for transportation
Fig. 6
Rear panel
▲ marks Fig. 7
Left
tubing
Right tubing
Downward tubing
Right-rear
tubing
(recommended)
Left-rear
tubing
Fig. 8a
3. How to Install the Indoor Unit
3-1. Remove the Rear Panel from the Unit
(1) Remove and discard the set screw on the rear panel. (Fig. 6)
(2) Press the 2 ▲ ▲ marks on the frame cover and disengage the sta-
tionary tabs from the frame. (Fig. 7)
(3) Remove the rear panel.
Tubing can be extended in 5 directions (KHS0951, KHS1251 and
KHS1852) as shown in Fig. 8a or 8b. Select the direction you need
providing the shortest run to the outside unit.
3-2. Make a Hole
(1) Place the rear panel from the indoor unit on the wall at the loca-
tion selected. Make sure the panel is horizontal, using a carpen-
ter’s level or tape measure to measure down from the ceiling.
Wait until after cutting the hole before attaching the rear panel to
the wall.
(2) Determine which side of the unit you should make the hole for
tubing and wiring. (Fig. 9)
(3) Before making the hole, check carefully that no studs or pipes
are directly run behind the spot to be cut.
NOTE
Fig. 9
In case of right-rear
KHS0951, KHS1251
KHS1852
CAUTION
● Also avoid areas where electrical wiring or conduits are
located.
● Switching drain hose and drain cap
(a) Locate the drain hose and the drain cap. (Fig. 8c)
(b) Remove the drain hose on the right side by pushing and
turning the hose connector counter-clockwise to release it.
(Fig. 8c)
(c) Apply moderate force to pull off the drain cap on the left
side. (If you cannot pull it off by hand, use a long-nose pli-
ers.)
(d) Reattach the drain hose to the left side and the drain cap
to the right side. (Fig. 8c)
The above precautions are also applicable if tubing goes through the
wall in any other location.
Left
tubing
Right-rear
tubing
(recommended)
Right tubing
Downward tubing
Fig. 8b
60 °
Drain hose
Clamp
Drain cap
To slip on
To remove
Fig. 8c
01-385 AirCon 12/11/01 4:41 PM Page 6