Sony UP-50 - Manual (Page 75)

75 Installation and Adjustment
a) This selector is supplied with models other than UP-51MDU. Set the NTSC/PAL selector to your
TV system. To switch the TV system, turn the power off once, then change the setting. If you
change the setting with the power on, this mode will not be switched.
b) Two kinds of 75-ohm termination switches are provided; one is for the RGB input and the other is
for the composite video signal. Normally set this switch to ON. Set it to OFF if the level of the
input signal drops because the signal is divided to additional video equipment other than the
printer.
Making Connections for Viewing Images to be Printed
Connect a video monitor to view stored images and to check those to be printed.
Connect the required video monitor which will be used in actual printing, using the
following diagram as a guide.
Before connecting the video equipment, see “Important safeguards/notices for use
in the medical environments” for UP-51MD/51MDU/51MDP on page 2.
to S-VIDEO
OUTPUT
to VIDEO OUTPUT
to RGB/SYNC OUTPUT b)
to S-VIDEO
input
connector to composite
video input
connector
to RGB input
connectors Video monitor
to AC IN
AC power cord
(supplied)
to wall outlet
75-ohm coaxial
cable with BNC
connectors
Connecting cable (with
DIN 4-pin connectors)
YC-15EV
NTSC/PAL selector a)
75-ohm coaxial
cable with BNC
connectors
NTSC PAL
a) This selector is supplied with models other than UP-51MDU. Set the NTSC/PAL selector to your
TV system. To switch the TV system, turn the power off once, then change the setting. If you
change the setting with the power on, this mode will not be switched.
b) See “When connecting the video monitor to the RGB SYNC OUTPUT connectors” on the next
page.