Sony UP-50 - Manual (Page 74)

74 Installation and Adjustment
Connections
To enable printing, video equipment to act as an input signal source, and a video
monitor to display images or menus must be connected.
The following diagrams illustrate how to make the input, output and remote control
connections. Use this as a guide when connecting the required signals to and from
the equipment to be used for printing.
Notes
• Turn off the power of each device before attempting to make any connections.
• Connect the AC power cord last.
Making Connections for Capturing Video Images
Connect the video equipment providing the video images to be printed.
Connect the video equipment which will be used in actual printing, using the
following diagram as a guide.
Before connecting the video equipment, see “Important safeguards/notices for use
in the medical environments” for UP-51MD/51MDU/51MDP on page 2.
to RGB output connectors
to S-VIDEO
output
connector
to composite video
output connector
Video equipment
to S-
VIDEO
INPUT
to RGB/SYNC INPUT
to VIDEO INPUT
to AC IN
AC power cord
(supplied)
to wall outlet
Connecting cable (with DIN 4-pin connectors) YC-15EV
75-ohm coaxial cable with the BNC connectors
NTSC/PAL selector a) 75-ohm termination
switch
b)
NTSC PAL
ON
OFF
75-ohm coaxial cable with the BNC connectors