Kenwood KRF-X9992D - Manual (Page 19)

13
Chapter One : Connecting Your Devices Audio-Video Receiver KRF-X9992D
Connections
Connecting Your VCR(s), continued
Do not plug in the receiver to AC power until you
have connected all your devices.
This section focuses on the connections from your
VCR to the KRF-X9992D. Please refer to your VCR’s
instructions for more detail about its connection
jacks and capabilities.
The instructions in this section show one of several
possible variations on connecting your VCR. For
further assistance on optional configurations,
contact the store where you purchased your receiver.
To Connect a Primary VCR:
1. Review the information under “Before You
Begin” on page␣ 1. It contains important notes
about the types of video connections you can
make.
2. Connect the audio and video cables from the
VCR’s Audio and Video jacks to the receiver’s
VIDEO 1 REC OUT and PLAY IN jacks as shown
to the left.
3. Be sure to connect the VCR Video IN cable to the
jack labeled REC OUT and the VIDEO OUT
cable to the jack labeled PLAY IN.
4. Go to “Noting Your Devices” on page␣ 3 and note
which jack you used to connect your VCR. In
addition, note the brand name and model
number of the VCR.
To Connect a Secondary VCR:
1. Review the information under “Before You
Begin” on page␣ 1. It contains important notes
about the types of video connections you can
make.
2. Connect the audio and video cables from the
VCR’s Audio and Video jacks to the receiver’s
VIDEO 2 REC OUT and PLAY IN jacks.
3. Be sure to connect the VCR Video IN cable to the
jack labeled REC OUT and the VIDEO OUT
cable to the jack labeled PLAY IN.
4. Go to “Noting Your Devices” on page␣ 3 and note
which jack you used to connect your VCR. In
addition, note the brand name and model
number of the VCR.