Kenwood KRF-X9992D - Manual (Page 37)

31
Chapter One : Connecting Your Devices Audio-Video Receiver KRF-X9992D
Connections
Connecting the Antennas
AM Loop Antenna
Your new receiver comes with an AM loop antenna
for AM radio reception. To connect the AM antenna:
1. Insert the antenna loop into the base and
position the loop.
2. Open the receiver’s antenna terminal levers.
3. Insert the antenna’s wires into the terminal as
shown above.
4. Close the antenna terminal levers to lock the
wires in place.
5. Adjust the antenna loop as necessary to improve
reception.
To prevent hum interference, keep the AM antenna
wires away from speaker wires, AC power cords, the
TV chassis, and the receiver.
FM Indoor Antenna
Your new receiver also comes with an FM indoor
antenna for FM radio reception. To connect the FM
antenna:
1. Attach the antenna sheath to the pole in the
center of the receiver’s FM antenna jack, as
shown above. When you attach the sheath for the
first time, you may need to exert quite a bit of
pressure.
2. Adjust the antenna as necessary to improve
reception.
3. Tack the looped end of the antenna in the
location that provides the best reception.
FM Outdoor Antenna
Kenwood recommends a permanently installed
outdoor FM antenna for best FM reception. To
connect an outdoor FM antenna:
1. Connect the antenna wire to a standard,
commercially available antenna adapter as
shown above.
2. Connect the adapter to the receiver’s FM antenna
jack.
What if I Have Cable Radio?
If you have cable radio, contact your cable provider
for assistance with connecting to the KRF-X9992D.