Kenwood KRF-X9992D - Manual (Page 31)

25
Chapter One : Connecting Your Devices Audio-Video Receiver KRF-X9992D
Connections
Connecting Your Laser Disc Player (with AC-3 RF Output), continued
Do not plug in the receiver to AC power until you
have connected all your devices.
You must purchase an RF Demodulator (DEM-
9991D) if you plan to operate a player with a Dolby
Digital (AC-3) RF Output with this receiver.
These instructions describe how to connect a laser
disc player with an AC-3 RF Output. If your laser
disc player does not have an AC-3 RF output, see
“Connecting Your Laser Disc Player (without AC-3
RF Output)” on page␣ 26. Please refer to your laser
disc player’s instructions for more detail about its
connection jacks and capabilities.
The instructions in this section show one of several
possible variations on connecting your laser disc
player. For further assistance on optional configura-
tions, contact the store where you purchased your
receiver.
To Connect an AC-3 RF Output Laser
Disc Player:
1. Review the information under “Before You
Begin” on page␣ 1. It contains important notes
about the types of video connections you can
make.
2. Connect the audio cables from the laser disc
player’s Audio OUT jacks to the receiver’s AUDIO
jacks (VIDEO2 or VIDEO3 PLAY IN) as shown to
the left.
3. For the video cable connection, you must use the
VIDEO2 or VIDEO3 jack set, as that is the set
with a coaxial digital connection.
Do not connect the digital cable (coaxial or
optical) yet; it must be connected via the de-
modulator as described in the following steps.
4. Connect the AC-3 RF coaxial cable from the laser
disc player’s AC-3 RF OUT jack to the demodula-
tor’s RF INPUT AC-3 RF jack as shown to the left.
5. Connect the digital cable (either coaxial or
optical) from the laser disc player’s digital jack to
the appropriate DIGITAL INPUT jack on the
demodulator as shown to the left. Set the switch
on the front of the DEM-9991D to the type of
connection you made.
6. Connect the coaxial digital cable from the
demodulator’s DIGITAL OUTPUT COAX. jack to
the receiver’s VIDEO2 or VIDEO3 COAXIAL jack.
7. Connect the demodulator’s supplied 12V AC
adapter to the DC IN jack on the demodulator.
Do not plug the adapter into the wall until you
have finished making all connections to the
receiver.
8. Go to “Noting Your Devices” on page␣ 3 and note
which jacks you used to connect your laser disc
player. In addition, note the brand name and
model number of the laser disc player.