Kenwood KRF-X9992D - Manual (Page 39)

33
R
emote Setup
Chapter Two : Setting Up PowerTouch Audio-Video Receiver KRF-X9992D
Calibrating the Touch Screen
After you install the batteries or reset PowerTouch,
you need to calibrate the touch screen. The touch
screen responds to pressure from the included stylus
or your finger:
If you are replacing batteries and complete the
battery replacement within 3 minutes, you do not
need to calibrate the screen; calibration is stored in
memory.
If the screen’s performance begins to change, you can
recalibrate it without resetting PowerTouch by
pressing on the Setup Preference menu. For
more information about accessing this menu, see
“Identifying Devices For PowerTouch Control” on
page␣ 37.
To calibrate the touch screen, use the stylus to touch
the center of each of the calibration points displayed
When you touch each calibration point, you should
hear a beep and see the next point, indicating that
area of the screen is now calibrated. If you do not
hear a beep, touch the calibration point until you do.
The touch screen is sensitive to pressure, not to
movement. Press firmly but gently on any touch screen
element. The screen will not respond if you simply
brush the stylus or your finger along the surface.
Resetting PowerTouch
If you want to reconfigure PowerTouch, you can
reset it. You do not need to do this unless you
experience a problem.
1. Open the cover.
2. Use the stylus to press the blue button at the
bottom of the battery case:
The items you set up in this chapter will remain in
PowerTouch. If you want to make it to the factory–
set default condition, please follow the instructions
on page 78 of the Users’ Guide.