Kerio Tech KERIO WINROUTE FIREWALL 6 User Manual
Page 143
11.1 Web interface preferences
143
Configuration of ports of the Web Interface
Use the TCP ports section to set ports for unencrypted and encrypted versions of the Web
interface (default ports are 4080 for the unencrypted and 4081 for the encrypted version of
the Web interface).
Figure 11.2
Configuration of ports in WinRoute’s Web Interface
Hint: If no WWW server is running on the WinRoute host, the standard port of the HTTP
protocol (i.e. 80) can be used for the unsecured web interface and the standard port of the
HTTPS protocol (i.e. port 443) for the secured web interface. If standard ports are used, the
port number is not necessarily required in URLs for pages of the web interface.
However, in WinRoute for Windows, the standard HTTPS port (443) uses the Clientless SSL-VPN
interface (see chapter
). Therefore, it cannot be used for secured web interface in the default
configuration.
Warning
If any of the entries are specified by a port which is already used by another service or ap-
plication, and the Apply button (in Configuration → Advanced Options) is clicked, WinRoute
will accept this port, however, the Web interface will not run at the port and an error in the
following format will be reported in the Error log (see chapter
):
Socket error:
Unable to bind socket for service to port 80.
(5002) Failed to start service "WebInterface"
bound to address 192.168.1.10.
If you are not sure that specified ports are free, check the Error log immediately after clicking
Apply to find out whether the corresponding error has been logged.