Debug log, 6 debug log – Kerio Tech KERIO WINROUTE FIREWALL 6 User Manual
Page 271
22.6 Debug Log
271
•
[18/Apr/2008 10:22:47]
— date and time when the event was logged (note: Con-
nection logs are saved immediately after a disconnection).
•
[ID] 613181
— WinRoute connection identification number
•
[Rule] NAT
— name of the traffic rule which has been used (a rule by which the traffic
was allowed or denied).
•
[Service] HTTP
— name of a corresponding application layer service (recognized by
destination port).
If the corresponding service is not defined in WinRoute (refer to chapter
), the
[Service]
item is missing in the log.
•
[User] james
name of the user connected to the firewall from a host which partici-
pates in the traffic.
If no user is currently connected from the corresponding host, the [User] item is
missing in the log.
•
[Connection] TCP 192.168.1.140:1193 -> hit.top.com:80
— protocol, source
IP address and port, destination IP address and port. If an appropriate log is found in
the DNS module cache (see chapter
), the host’s DNS name is displayed instead of
its IP address. If the log is not found in the cache, the name is not detected (such DNS
requests would slow WinRoute down).
•
[Duration] 121 sec
— duration of the connection (in seconds)
•
[Bytes] 1575/1290/2865
— number of bytes transferred during this connection
(transmitted /accepted /total).
•
[Packets] 5/9/14
— number of packets transferred through this connection
(transmitted/accepted/total).
22.6 Debug Log
Debug (debug information) is a special log which can be used to monitor certain kinds of
information, especially for problem-solving. Too much information could be confusing and
impractical if displayed all at the same time. Usually, you only need to display information
relating to a particular service or function. In addition, displaying too much information slows
WinRoute’s performance. Therefore, it is strongly recommended to monitor an essential part
of information and during the shortest possible period only.
Selection of information monitored by the Debug log
The window’s context menu for the Debug log includes (see chapter
) further options for
advanced settings of the log and for an on-click one-time view of status information.
Note: These options are available only to users with full administration rights for WinRoute
(see chapter
IP Traffic
This function enables monitoring of packets according to the user defined log expression.