Kodak 6B6640 - Manual (Page 21)

Troubleshooting
March 2001 2-5
117 A software error has been
detected by the following
device: _devicename_ Error
Message: _errmsg_ An error has occurred on the
printer. Resolve printer error condition.
118 A SCSI ID for the following
device was not found:
_devicename_. SCSI driver not found. Reinstall the SCSI driver on host
computer.
119 The wrong SCSI ID was
specified for the following
device: _devicename_. SCSI ID is incorrect. Set the Target SCSI ID to the
printer SCSI ID.
120 This device has been setup
for the wrong model of
printer: _devicename_. The chosen device has not been
found. Verify chosen device matches the
printer model.
121 Unable to read STATUS from
device: _devicename_. Unable to see the printer. Check SCSI cable connections.
122 The selected LUT contains
data that exceeds the limits
of this printer. Trying to send a 12-bit LUT to a
10-bit printer. Select a 10-bit LUT file.
201 An error occurred while
trying to allocate memory. The system is trying to allocate
memory; however, no memory is
available. Close any unnecessary
applications.
202 The following parameter is
invalid:_parametername:
_parametervalue_. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
203 The function is not supported
by the class. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
204 This function has not been
implemented. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
Code Status Message Possible Cause/Subsystem Possible Solution