Kodak 6B6640 - Manual (Page 23)

Troubleshooting
March 2001 2-7
702 Patch _patch_ has a spread
of _spread_ which is out of
range _range_. The spread between colors for a
given density patch is out of
tolerance. Perform another calibration cycle.
703 CalToleranceFile can only be
initialized once. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
704 CalToleranceFile::
initialize must be called first. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
801 Could not find row:_row_. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
802 Could not find
column:_column_. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
803 Could not find element -
column:_column_.
row:_row_. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
804 Row value was not set
before using. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
805 Column value was not set
before using. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
806 Error deleting row:_row_. An internal error occurred with the
software. • Restart the application.
• If problem continues, call for
service.
807 Element at row:_row_;
column:_col_
value:_val_ failed audit. An input file had incorrectly
formatted data in it at the location
indicated. • Verify that you are using the
correct file.
• Edit the file and correct the
format.
Code Status Message Possible Cause/Subsystem Possible Solution