Kyocera Finecam L4 - Manual (Page 8)

Introduction
8
Introduction
Handling Precautions
<Precautions for Operating the Camera>
● This camera is not designed to be waterproof, and cannot be used in the rain or under water. If the camera
should inadvertently be exposed to water, it should be taken quickly to a Kyocera/Yashica Service Center
for inspection.
● Fingerprints or smudges on the camera’s lens or light sensors may adversely affect the precision of the
camera. If soiling occurs, use a piece of clean chamois or commercially available lens tissue to gently wipe
away the smudge. Do not apply excessive pressure or touch the lens with any rough material. An air
blower or lens brush may be used to remove loose dust or dirt from the lens.
● Clean the camera body by wiping with soft cloth. Never use benzene, thinner, or other volatile solvents or
cleansers, since such substances will damage the body materials.
● Do not remove the Memory Cards while the card access LED is flashing.
Caution and Warning Symbols
These Operating Instructions feature the following caution and warning symbols to indicate items of
special importance. Be sure to read the contents of these warnings carefully, and use the features
correctly.
WARNING
● If camera or batteries become hot, emit smoke or a burning smell, or display other
abnormal symptoms, remove them from the camera immediately to prevent fire. When
handling the batteries, take precautions to avoid being burned.
● Never attempt to disassemble or modify the camera, since you may receive a severe
electric shock.
● Do not operate the electronic flash at close proximity to a person's eyes (especially
those of an infant), since eye damage may result.
● Do not look through the camera directly at the sun or other strong light source, since
your eyesight may be damaged.
● Do not attempt to take pictures while driving or walking, particularly when looking
through the viewfinder or at the LCD monitor, since you may cause an accident.
● When taking pictures, remain aware of your surroundings and what is happening
around you.
CAUTION
● Clean the camera well after using it at the beach or other locations subject to large
concentrations of sand or dust. Salt air may promote corrosion of metal components
and damage or short circuits in electronic parts, causing the camera to emit smoke or
catch fire. Sand inside the camera may result in internal damage and operating
malfunctions.
● If the camera is brought quickly from a cold place to a warm room, condensation may
form on the lens and internal parts. Such condensation may result in damage or short
circuits in electronic parts, causing the camera to emit smoke or catch fire. Whenever
possible, avoid subjecting the camera to sudden changes in temperature, and if
condensation occurs, turn off the camera power quickly and leave it off until all
condensation is gone.
● This camera is a precision electronic instrument, and should be protected from
impacts and falls that might cause damage to internal parts or the shorting of circuitry.
● When taking the camera overseas or using it to record important events, check its
operating condition and take test pictures beforehand to confirm proper operation.
DANGER
This symbol indicates procedures which have a high likelihood of resulting in death or
serious personal injury if not followed properly.
WARNING
This symbol indicates handling procedures which may result in death or personal injury
if not followed properly.
CAUTION
This symbol indicates procedures which may result in injury to the user, or physical
damage to the product if not followed properly.
Make sure to read this page carefully.
00_8CQ.book Page 8 Wednesday, May 14, 2003 8:10 PM