Lucent Technologies Voice Terminal 8411 - Manual (Page 20)

17
The second line on each feature option screen shows the features you can access. To use any of
these features, you must press the softkey below the feature name or abbreviation. For example,
on the feature option screen shown above, you can leave a message for another extension to call
you back by pressing the softkey below LWC (the Leave Word Calling feature). If you want to
cancel the message, press the softkey below CnLWC (the Cancel Leave Word Calling feature).
To see the next set of four features, press the display control button labeled ; to move
back a screen, press the display control button labeled . Press or until
the feature you want to use appears on the second line.
The following flowchart (Figure 5) shows the default features for the three feature option screens.
These are the 12 softkey features available when the voice terminal (with display) is shipped from
the factory. Also, see “Other Softkey Features That May Be On Your Display” in this section.
Next
Prev Next Prev
Figure 5. The Three Default Feature Option Screens
Note: An error tone (one beep) sounds when you have made a mistake in your softkey entries.
Press at any time to exit softkey mode and return to Normal (call-handling) Mode.
LWC CnLWC AutCB Timer
CFrwd CPark TmDay PCall
Prog Pause Mark Wait
Leave
Word
Calling
Cancel
LWC
Automatic
Callback
Timer
Call
Forwarding
Call
Park
Time/
Date
Priority
Calling
Abbreviated
Dialing (AD)
Program
AD
Pause
AD
Mark
AD
Wait
Exit