Lantronix Device Server UDS 10 - Manual (Page 73)

Firmware
UDS-10 User Guide 4-5
4. In the Destination File field, enter the current internal operational code or WEB5 for
the internal Web interface. (For UDS-10-IAP, AQ = Standard Tunnel, AM = Modbus,
AD = DF1. For UDS-10, 3Q = Standard Tunnel)
5. In the Remote Host field, enter the IP address of the unit being upgraded.
6. Click the Put button to transfer the file to the unit.
Figure 18 - TFTP Dialog Box
The unit performs a power reset after the firmware has been loaded and stored.
4.2.3 Via Another Unit
To distribute firmware to another unit over the network:
1. Enter the host unit's Monitor Mode (see Monitor Mode on page 7-1).
2. Send the firmware to the receiving unit using the SF command, where x.x.x.x is the
receiving unit's IP address.
SF x.x.x.x
The receiving unit performs a power reset after the firmware has been loaded and stored.
Note: You can only update your unit 's internal Web interface using TFTP or Device
Installer.