Lantronix Device Server UDS 10 - Manual (Page 86)

Monitor Mode
7-2 UDS-10 User Guide
Table 17 - Monitor Mode Commands
Command Command Name Function
DL Download Download firmware to the Device Server via the
serial port in hex format
SF x.x.x.x Send Firmware Send firmware to Device Server with IP address
x.x.x.x
VS x.x.x.x Version Query software header record (16 bytes) of
Device Server with IP address x.x.x.x
GC x.x.x.x Get Configuration Get configuration of Device Server with IP
address x.x.x.x as hex records (120 bytes)
SC x.x.x.x Send Configuration Set configuration of Device Server with IP address
x.x.x.x from hex records
PI x.x.x.x Ping Ping Device Server with IP address x.x.x.x to
check device status
AT ARP Table Show the Device Server’s ARP table entries
TT TCP Connection
Table
Shows all incoming and outgoing TCP
connections
NC Network Connection Shows the Device Server’s IP configuration
RS Reset Resets the Device Server’s power
SI
xxx.xxx.xxx.xxx:
yyy.yyy.yyy.yyy Send/Set IP
Address Remotely assign an IP address to a Device
Server, where xxx.xxx.xxx.xxx is the IP address,
and yyyy.yyy.yyyy.yyy is the two-part identification
number at the bottom of the label, converted to
decimal, and written twice.
QU Quit Exit diagnostics mode
G0, G1, ....,Ge,
Gf Get configuration
from memory page Gets a memory page of configuration information
from the device.
S0, S1,...,Se, Sf Set configuration to
memory page
Sets a memory page of configuration information
on the device.
Responses to some of the commands are given in Intel Hex format (see The Intel Hex Format
on page 8-5).
Note: Entering any of the commands listed above will generate one of the following command
response codes:
Table 18 -Command Response Codes
Response Meaning
0> OK; no error
1> No answer from remote device
2> Cannot reach remote device or no
answer
8> Wrong parameter(s)
9> Invalid command