LSI MegaRAID Enterprise 1600 - Manual (Page 72)

MegaRAID Enterprise 1600 Hardware Guide 58
SCSI Termination, Continued
Terminating External Disk Arrays In most array enclosures, the end of the SCSI cable has an independent SCSI
terminator module that is not part of a SCSI drive. In this way, SCSI termination is not disturbed
when a drive is removed. MegaRAID termination should always be enabled or controlled by
software. Make sure J2, J3, J5, and J7 are either always open (termination always enabled), or Pins
1-2 are shorted (termination controlled by software).
Note: Channels C and D have only external connectors, so termination should always be either
anabled or under software control on these two channels.