LSI MegaRAID Enterprise 1600 - Manual (Page 86)

MegaRAID Enterprise 1600 Hardware Guide 72
Step 14 Install the Operating System Driver
Important
When booting the system from a drive connected to a MegaRAID controller
and using EMM386.EXE, MEGASPI.SYS must be loaded in CONFIG.SYS
before EMM386.EXE is loaded. If you do not do this, you cannot access the
boot drive after EMM386 is loaded.
DOS ASPI Driver The MegaRAID DOS ASPI driver can be used under DOS, Windows 3.x, and Windows 95. The
DOS ASPI driver supports:
• up to six non-disk SCSI devices (each SCSI device must use a unique SCSI ID regardless of the SCSI
channel it resides on. SCSI IDs 1 through 6 are valid
• up to six MegaRAID adapters (you should only configure one MegaRAID adapter per system if
possible)
ASPI Driver The ASPI driver is MEGASPI.SYS. It supports disk drives, tape drives, CD-ROM drives, etc. You
can use it to run CorelSCSI, Novaback, PC Tools, and other software that requires an ASPI driver.
CorelSCSI, Novaback, and PC Tools are not provided with MegaRAID. Copy MEGASPI.SYS to
your hard disk drive. Add the following line to CONFIG.SYS. MEGASPI.SYS must be loaded in
CONFIG.SYS before EMM386.EXE is loaded.
device= <path>\MEGASPI.SYS /v
Parameters The MEGASPI.SYS parameters are:
Parameter Description
/h INT 13h support is not provided.
/v Verbose mode. All message are displayed on the screen.
/a Physical drive access mode. Permits direct access to physical drives.
/q Quiet mode. All message except error message are suppressed.
Cont’d