Liebert Refrigerant Distribution Unit XDP - Manual (Page 9)

Product Description
3
4. Remove the two (2) end deck boards from one end of the pallet and the attached, notched section
of the center runners (refer to Figure 3).
Figure 3 Removing pallet boards for piano jack insertion
5. Place a piano jack with its forks snugly against the bottom of the unit and strap the Liebert XDP
securely to the jack (refer to Figure 4).
Figure 4 Liebert XDP strapped to piano jack
6. Repeat Steps 2, 4 and 5 for the opposite side of the unit. When these steps have been completed,
the Liebert XDP will be supported by two piano jacks, one on either side.
7. Remove all of the remaining lag bolts from one (1) of the pallet’s outside runners (see Figure 5).
Figure 5 Remove remaining lag bolts from one runner
NOTE
Place a mover’s blanket or other cushioning material between the piano jack and the
unit’s side panels.
... and center runner sections
from one end of pallet.
Remove two deck boards ...
Piano jack
Strap secures the
Liebert XDP to the jack
Place cushioning material
between the forks and the Liebert
XDP to protect unit’s finish
(cushion not shown for clarity)
Piano jack’s forks should be
snug against the Liebert XDP
Remaining 6 lag bolts
to remove