Lanier LW 210 - Manual (Page 33)

4
Specify values for each setting.
You can store the following settings with the Program function. For the
way to specify values, see the corresponding pages.
•
Sample copying
→
See page 21.
•
Partial copying (The start and end points cannot be stored)
→
See page
19.
•
Paper feeder
→
See page 22.
•
Copy exit
→
See page 10.
•
Margins
→
See page 12.
•
Cut type
→
See page 14.
•
Number of copies
→
See page 8.
•
Copy density
→
See page 9.
•
Fusing temperature
→
See page 7.
✏
You can also store the paper type and roll width. However, these
settings cannot be changed with the Program function. When you
specify a paper feeder, the paper type and roll width specified with the
Paper Type/Roll Width Entry function (see page 22) are stored.
5
Press the Enter key.
The copy settings are stored.
6
If you store settings for another
program number, repeat
2 to 5 .
7
Press the Program key.
The lamp on the Program key
lights.
✏
The settings are also stored
when you press the Program
key instead of the Enter key.
USING THE PROGRAM FUNCTION
COPYING 25