Lanier LW 210 - Manual (Page 41)

WHEN A OR x IS LIT
A paper jam has occurred. The corrective action varies depending on the
location having the misfed paper. Remove the paper according to the corre-
sponding instruction shown below.
✏
Be sure to remove the paper completely without tearing it. If a piece of the
paper remains inside the copier, the paper jam might recur or another fault
might occur.
R
WARNING: Do not remove any covers or screws other than those
specified in this manual. Some parts of the copier are at a
high voltage and could give you an electric shock. When
the copier needs to be checked, adjusted or repaired,
contact your service representative.
R
Caution: When removing misfed paper, do not touch the fusing
section because it could be very hot.
S
A location having misfed paper is
shown by an indicator on the ope-
ration panel.
S
Several locations might be indicated simultaneously. Remove misfed paper
from all of the locations.
S
When you open the original table, paper path section, or rear cover, the
copier turns itself off. However, the copy settings are kept stored.
S
When you have removed misfed paper, the suspended copy settings are
displayed. Resume copying without changing the settings.
S
If paper jams occur repeatedly, contact your service representative.
WHAT TO DO IF SOMETHING GOES WRONG 33