Lexmark 5021-0XX - Manual (Page 82)

2-4 Service Manual
5021-0XX
920
Fuser thermistor
error
Go to “920—Fuser thermistor service check” on
page 2-60 .
921/922/923/924/925
Fuser temperature
error
Go to “921,922,923,924,925—Fuser assembly
service check” on page 2-61 .
92X
Fuser exhausted
Fuser is in a maintenance state and needs to be
replaced before any other action can be taken.
Replace fuser assembly (see “Fuser assembly
removal” on page 4-9 ) and note whether any error
code exists.
Note: Fuser is a customer-order supply.
930
Laser power error
Indicates that printhead laser output is low.
Go to “930,931,932—Laser unit assembly service
check” on page 2-62 .
931
Beam detector error
(BDT)
Indicates that printhead laser scanning beam is not
detected by the beam sensor.
Go to “930,931,932—Laser unit assembly service
check” on page 2-62 .
932
Scanner motor error
(SM)
Indicates abnormal rotation of printhead scanner
motor.
Go to “930,931,932—Laser unit assembly service
check” on page 2-62 .
939
RIP to engine
communication
Indicates that the RIP board processor cannot
communicate with processor. Remove and reinstall
RIP board. Go to
“RIP board removal” on
page 4-45 . Ensure RIP board makes proper
connection with engine controller board connector.
Ensure engine controller board is properly installed.
If error persists, replace RIP board. If error still
persists, replace engine controller board. See
“Engine controller board removal” on page 4-55 .
945
Engine board
NVRAM error
Turn power off and then back on.
If error still exists, replace engine controller board.
Go to
“Engine controller board removal” on
page 4-55 .
Error code Action