Lowrance electronic Lowrance GlobalMap 7200C - Manual (Page 134)

126
8. Repeat Steps 5-7 for each remaining tank.
9. When all tanks have been configured, press the
S
ET
C
ONFIGURATION
but-
ton. The following confirmation message will appear: Are you sure you
wish to change the bus configuration? Choose
Y
ES
and press
ENT
, Press
EXIT
to get back to the main display.
Device Configuration Menu
When a device is selected from the network devices list on the Bus Con-
figuration menu, its Device Configuration menu will appear. Device
configuration menus vary among devices. Available functions on device
configuration menus allow you to change device names, tank sizes,
fluid types and provide access to the Advanced Options menu. We will
cover configuration and calibration later in this section.
Device Information and Device Data
The Device information panel, located to the left of the Device Configura-
tion menu, displays information on the selected device that includes, soft-
ware version, model, address, serial number, instance and current status.
If you do not have an EP-15 Fluid Level, EP-10 Fuel Flow or EP-20 En-
gine Interface on the network, the Bus Configuration menu will not
display the Engine-Tank Configuration menu, Tank Select menu, Tank
Size menu or Set Configuration button.
Device Data is shown in the Device Data window at the bottom of the de-
vice configuration menu. The information displayed in the Device Data
window will vary among devices. If, for example, you are viewing the de-
vice configuration menu for an EP-15 Fluid Level, the device data window
will include tank size and the amount of fuel left in the tank. The Device
Data for an EP-10 Fuel Flow includes Fuel Rate (amount of fuel burned
per hour), Fuel Used, Trip Fuel Used and Seasonal Fuel Used.
NOTE:
If, as in the graphic above, you do not have a Suzuki Engine Inter-
face, EP-15 Fluid Level or EP-10 Fuel Flow on the network, the