Lowrance electronic Lowrance GlobalMap 7200C - Manual (Page 38)

30
1. PWR/LIGHT (Power & Light) – The PWR key turns the unit on and
off and activates the backlight.
2. PAGES – Pressing this and the
← → arrow keys (4) switches the
unit between the three different page screens (Satellite Status Page,
Navigation Page, Map Page and Radar Page). Each page represents
one of the unit's major operation modes.
3. MENU – Press this key to show the menus and submenus, which
allow you to select a command or adjust a feature. This also accesses
search functions for streets, intersections, addresses and highway exits.
4. ARROW KEYS – These keys are used to navigate through the
menus, make menu selections, move the map cursor and enter data.
5. ENT/ICONS (Enter & Icons) – This key allows you to save data, ac-
cept values or execute menu commands. It is also used to create event
marker icons.
6. EXIT – The Exit key lets you return to the previous screen, clear
data or close a menu.
7. WPT – (Waypoint) The Waypoint key is used to save and recall way-
points, search for waypoints and access the waypoint list. It also
launches the Point-of-Interest (POI) search menus and is involved in
some navigation functions.
8. ZOUT – (Zoom Out) – This key lets you zoom the screen out. On the
Map Page, this lets you see a larger geographic area on the map. Less
detail is seen as you zoom out.
9. ZIN – (Zoom In) – This key lets you zoom the screen in. On the Map
Page, zooming in lets you see more detail in a smaller geographic area
on the map.
Power/lights on and off
To turn on the unit, press
PWR
. As the unit powers up, the Map Page is
displayed first (To switch to another page, press
PAGES
| ← or → to Page
Name|
EXIT
.).
To turn on the backlight, press
PWR
again. The unit has three back-
light levels to select from. Repeatedly pressing
PWR
will cycle through
the backlight settings and turn off the backlight.
Turn off the unit by pressing and holding the
PWR
key for 3 seconds.
Main Menu
The GlobalMap has a Main Menu, which contains some function com-
mands and some setup option commands. The tutorial lessons in this
section will deal only with functions, the basic commands that make
the unit do something. The unit will work fine for these lessons right