Lowrance electronic Lowrance GlobalMap 7200C - Manual (Page 35)

27
Slide the drawer back into the unit and twist the retainer clockwise. The
MMC is now ready for use.
In the GlobalMap 9200 and GlobalMap 9300, the two MMC slots are located
in compartments on the front of the case. The water-proof compartment doors
are located at the lower right corner. The following figure shows a close-up of
one compartment with the door opened.
Memory card compartment with a 16 MB MMC card installed.
To remove an MMC or SD Card
1. Open the card compartment door by unscrewing the thumb screw. The
screw should only be finger tight. If it was over-tightened, use a thumbnail, a
coin or a screwdriver to open the door.
2. Use the ball of your finger or thumb and press down in the center of the
card, then drag the MMC from the slot. Or, use a thumbnail or fingernail to
grab the groove in the bottom of the MMC and drag it out. See the figure
above for the groove location.
To add an MMC or SD Card
1. Open the card compartment door.
2. Grasp the bottom of the MMC and push the top of the card into the
slot. Once the card is started, press down in the center of the card with
the ball of your finger or thumb and push the card all the way to the
left, until it is firmly seated in the slot.
3. Close the compartment door and fasten the thumbscrew finger tight.
Other Accessories
Other accessories include MMC cards, MMC card readers and Map-
Create™ custom mapping software for your computer. MMC card read-
ers are available in USB versions.
If these accessories are not available from your dealer, see the acces-
sory ordering information on the inside back cover of this manual.
Insert card face up,
this way
Thumb
screw
MMC groove for card removal