Lowrance electronic Lowrance GlobalMap 7200C - Manual (Page 140)

132
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-35
Temp Sensor's settings to factory defaults. If, for example, you execute the
Restore Defaults command from your Water Temp's Advanced Options
menu, only the settings for the Water Temp will be reset to factory de-
faults. Other temps on the network will not be affected.
To restore default settings
:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
ENT
. The Device Configura-
tion menu will appear.
4. Highlight
A
DVANCED
O
PTIONS
and press
ENT
.
5. Select
R
ESTORE
D
EFAULTS
and press
ENT
. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.
EP-10 Fuel Flow Configuration
To input Device Name:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the fuel flow you want to rename and press
ENT
. The Device Con-
figuration menu will appear with the Device Name dialog box highlighted.
4. Press
ENTER
and use ↑ ↓, ← → to input the desired name for the fuel
flow. Press
ENT
. Press
EXIT
repeatedly to get back to the main display.
To select a Location:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The NMEA
2000 menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fuel flow and press
ENT
. The Device Configuration
menu will appear.