Lennox Hearth EPIC40 - Manual (Page 6)

6
Pre-Installation
Features
Installation Options
Residential
Vented vertical and horizontal
Manufactured (mobile) home
Natural gas (NG) or propane (LP)
Bedrooms
Optional wall-mounted or remote thermostat
Venting
This stove can be vented with Security™ Secure Vent™
pipe*. Coaxial pipe diameters are 6-5/8” outer and 4” inner.
The combustion air for this stove is drawn from outside the
house through the outer DV (direct vent) pipe. Room air is
not required for combustion.
When planning your installation, select the correct length of
vent pipe for your particular requirements. Determine the
minimum clearance to combustibles from the rear of the
unit to the wall. It is also important to note the thickness of
the wall. Before cutting the vent hole through the wall make
sure that ALL vent and termination clearances (see Page
17) will be met.
Electrical
The standard fan motor requires 120 Volts AC for operation.
The stove is not dependent on the fan or an outside electri-
cal supply to operate. WARNING - Electrical Grounding
Instructions - This appliance is equipped with a three-
prong (grounding) plug for your protection against shock
hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug.
RATINGS
Epic™ 33 (EPIC33) Epic™ 40 (EPIC40)
NATURAL GAS LP GAS NATURAL GAS LP GAS
Max/Min Input BTUh 0-,000 Feet
(0-60 M) u
33,000 / 23,000 31,000 / 24,000 40,000 / 27,000 39,000 / 30,000
Manifold Pressure (IN. WC) 3.5 / 1.7 10.0 / 5.4 3.5 / 1.7 10.0 / 5.4
Min. Inlet Pressure (IN. WC) 5.0 11.0 5.0 11.0
P4 Efficiency w 56.98% 63.58% 63.54% 65.0%
Orifice (DMS) 0-,000 Feet (0-60 M) u #36/.106 IN. #52/.064 IN. #31/.120 IN. #49/.073 IN.
u Unit factory equipped for 0-000 FT/0-60 M, In Canada 0-4500 FT/0-370 M
v The Steady State Efficiency numbers based on maximum vent configuration.
w Tested to CSA P.4.-0 “Testing Method for Measuring Annual Fireplace Efficiency.
Electrical Rating: 0 VAC, 60 HZ, Less Than  Amps
Millivolt Valve
This stove is operated with a millivolt valve and therefore
burns even during a power outage.
Fuel
This stove comes from the factory equipped to burn natural
gas at a specified elevation. The stove can be converted to
burn LP gas (liquid propane) by changing the cassette (valve
and pilot assembly) or installing a conversion kit. Only Len-
nox Hearth Products conversion kits can be used to convert
from NG to LP or LP to NG. Contact your Lennox Hearth
Products dealer for details.
Specifications
Pipe:Type - direct-vent
Recommended manufacturer*
Security™ Secure Vent™*
Diameter - 6-5/8”x 4” for all installations
Stove Packaging List
The Epic™ gas stove comes with the following parts:
1 Stove Body with Burner Cassette
1 150 CFM Blower
1 3/8”x 9” Gas Pipe
1 3 pc. Brick Panel Set
1 4 pc. Log Set
1 Bag of Ember Material
1 Bag of Rock Wool
1 Bag of Flue Restrictors, Brick Panel Brackets and
Tap-tites
1 Power Cord
1 Epic 33 Conversion Orifice
1 Installation and Operation Manual
Options
One required: Black Painted, Gold, Brushed Nickel, or
Black Nickel Trim Kit
* Other approved chimney brand is Simpson Dura-Vent DV-GS.