Lennox Hearth EPIC40 - Manual (Page 9)

9
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation
Trim Installation:
CAUTION: Always ensure that plated surfaces are clean
and free of fingerprints before lighting stove. Fingerprints
will leave permanent blemishes if left on plated surface
when lit. When installation is complete, the trim should
be gently cleaned with a soft cloth and either alcohol or
glass cleaner. Do not overtighten nuts, overtightening can
create visible dimples on the plated surface.
Packaging List: Trim pieces (2) - gold, brushed nickel,
black nickel, or black, #6 nuts (6), #6 washers (6)
Tools Required: 5/16” nut driver or socket wrench
1. Remove the trim pieces and hardware from its packaging
and ensure that all pieces are present before beginning
installation. Take care not to scratch finished surfaces.
2. Open right side door by removing socket head cap screw
located on the bottom of the side door near the front.
3. Open front door. Put trim in place by inserting trim studs
into the corresponding holes in the door. The top piece
of trim will only fit in one direction, but the bottom piece
can be installed incorrectly. When placing the bottom
piece of trim, make sure there is a small gap between the
bottom of the trim piece and the bottom of the door. If
the trim extends below the bottom of the door, the trim
is on upside down.
4. Place one washer on each stud. Using a 5/16” nut driver,
snug up the nuts on each piece of trim. Do not finish
tightening nuts.
5.There should be approximately a 1/8” gap between the
edge of the trim and the top and bottom edges of the door.
Visually inspect the alignment of the trim and adjust if
necessary.
6. Finish tightening nuts. CAUTION - DO NOT OVERTIGHTEN
NUTS!!!
Figure 6