Liebert UPSTATION GXT 2U - Manual (Page 13)

9
R ACK -M OUNT UPS C ONVERSION AND I NSTALLATION
1. For slide rail installations, first remove the top/side fin. Slide the
top/side fin forward, then lift it up to remove. If desired, install the
optional rack mount handles that were shipped with the UPS.
Securing hardware and slide rails are sold separately. Contact your
local dealer or Liebert representative for these additional options and
any assistance needed.
2. Unpack the two slide assem-
blies and mounting hard-
ware. The slide assemblies
are interchangeable
between left-hand or right-
hand. Remove the inner
member of each slide
assembly (as seen at right)
by extending it to its outer-
most position, depressing
the locking mechanism and
then pulling the inner mem-
ber from the slide assembly.
NOTE
When rack mounted, the UPS must be supported by a shelf,
brackets or slide rails on each side. The rack mount handles
WILL NOT support the weight of the UPS. They are used to
move the UPS into and out of the rack.
+ –
AC INPU T BATT ERY UP S ON BYPASS
UPStation GXT
Optional rack mount handles
Inner
members
Slide assemblies
Locking
mechanism
Outer
members
Outer
members
Mounting
bracket