Proxima ASA Multimedia LCD Projectors - Manual (Page 24)

User’s Guide • 2–9
Chapter 2 • Detailed Setup
COMPUTER
The video Y-cable allows you to connect your computer to both
the Desktop Projector and to a separate computer monitor, so
that you can view computer video output on the monitor and
projection screen simultaneously.
Desktop Computers
The same procedure is used to connect a PC or a Macintosh to
your projector. Use the Y-cable appropriate for your system.
Figure 2-9
VGA and Macintosh connections
1. Make sure that the computer and monitor are turned off.
2. Unplug the monitor cable from your computer’s video
monitor port and attach it to the MONITOR end of the
Y-cable.
Note: To connect your desktop computer without a monitor,
connect one of the supplied video terminators to the MONITOR
end of the Y-cable. Use the appropriate terminator for your
system.
3. Locate the Y-cable's common end, marked CPU/MAC II for
Macintosh systems and COMPUTER/VGA for IBM–
compatibles. Plug it into the computer's monitor port.
VGA
(C454–6)
Macintosh
(C464–6)