Proxima ASA Multimedia LCD Projectors - Manual (Page 47)

User’s Guide • 3–7
Chapter 3 • Using the Desktop Projector
To access the Setup Menu, do either of the following:
• Push the MENU key to access the Levels Menu. Press the
MENU key again to access the Setup Menu, or
• Press the MENU key twice to skip the first window and go
directly to the Setup Menu.
SOURCE IMAGE COLORS PROJECTION
FREQUENCY LANGUAGE STORE? SETTINGS
VGA640x480 NORMAL 226981 FORWARD
800 ENGLISH NO FACTORY
Figure 3-4
Setup Menu
SOURCE
SOURCE is both a status and selection box. When you connect a
video input to an Audio/video-enabled model, this setting
identifies the input source detected by the projector.
If the projector detects an NTSC source, it defaults to that
setting. The projector cannot tell the difference between PAL or
SECAM. When PAL or SECAM is used, the Desktop Projector
defaults to PAL. The SOURCE setting allows you to select
SECAM as the video source input. (Use the STORE command to
set SECAM as the default.)
The Desktop Projector selects the best possible value based on the
incoming signal. If the image doesn’t look right (wrong colors,
image is off screen, image won’t sync properly, etc.), use the up or
down arrow keys to make an alternate selection.
The Setup
Menu