Proxima ASA Multimedia LCD Projectors - Manual (Page 43)

User’s Guide • 3–3
Chapter 3 • Using the Desktop Projector
Note: Press the MENU key twice in rapid succession to:
• Go directly to the Setup Menu, or
• Exit the Menu Window from the Levels Menu.
Hold down the MENU key for several seconds to calibrate
Cyclops. For more information, refer to the Cyclops User’s Guide.
Note: You cannot use Cyclops and Proxima’s Presentation
Control Software at the same time. To disable Cyclops and use
the software, hold the MENU key on the Control Panel down
when you turn the projector power on. This procedure will not
work with the remote control. To re-enable Cyclops, turn the
projector off and then turn it back on.
SYNC Keys
The SYNC keys compensate for fine variations in the timing of a
computer's video signal. Sync is only used with computer video.
Adjust this setting if you see uneven horizontal features, streaks or
shimmering in a graphic image. Press the upper or lower SYNC
key until the image stabilizes.
VIDEO Key
The VIDEO key is used to switch between computer video input,
NTSC/PAL/SECAM video input, or S-VHS input. This key is
only operational on Audio/video-enabled models.
Note: If you would like to add video to audio-enabled models,
you can order the Video Adapter Kit (A195). See Appendix B for
ordering information.