Proxima ASA Multimedia LCD Projectors - Manual (Page 51)

User’s Guide • 3–11
Chapter 3 • Using the Desktop Projector
Factory Defaults
The first time you turn the Desktop Projector on, the initial
factory settings are used. If you change any of these settings, you
can recall all of the factory defaults by choosing FACTORY from
the SETTINGS function.
Warning and alert lights located on the projector's control panel
indicate the projector's operating condition.
Brightness
Sync
Volume
Video
Menu/
Lamp
OVERTEMP
REPLACE LAMP
Overtemp
Warning Light
Replace Lamp
Alert Light
Figure 3-5
Warning lights
OVERTEMP Warning Light
The OVERTEMP light illuminates in the unlikely event that the
projector overheats. A thermostat automatically turns off power to
the lamp until the projector cools.
Warning and
Alert Lights