Philips AVCHD HDC-TM20 User Manual
Page 136
136
VQT2B30
Colour or brightness of
the image changes, or
you may see horizontal
bars in the image.
≥ Colour or brightness of the image may change, or you may
see horizontal bars in the image when the object is
recorded under fluorescent light, mercury light or sodium
light, etc., but this is not a malfunction. Record in auto mode
or set the shutter speed to 1/100 in areas where the power
supply frequency is 50 Hz, or 1/125 in areas of 60 Hz.
Object seems to be
warped.
≥ Object seems to be warped slightly when the object moves
across the image very fast, but this is because the unit is
using MOS for the image sensor. This is not a malfunction.
White round spots like
soap bubbles appear on
the recorded picture.
≥ If you take a picture with the
flash in a dark place or indoors,
white round spots may appear
on the picture caused by the
flash reflecting of particles of
dust in the air. This is not a
malfunction.
A characteristic of this is that the number of round spots
and their position differ in every picture.
“ERROR OCCURRED.
PLEASE TURN UNIT OFF,
THEN TURN ON AGAIN.”
is displayed.
≥ The unit has automatically detected an error. Restart the
unit by turning off and on the power.
≥ The power will be turned off in about 1 minute if the power
is not turned off and on.
≥ Repair is needed if it is repeatedly displayed even if it is
restarted. Detach the power connected, and consult the
dealer who you purchased this unit from. Do not attempt to
repair the unit by yourself.
VIERA Link does not
work.
[Setting on this unit]
≥ Connect with a HDMI mini cable (optional). (
≥ Press the MENU button, then touch [SETUP]
# [VIERA
Link]
# [ON]. (l 97)
≥ Turn the power to the unit off and then back on again.
[Setting on other devices]
≥ Depending on HDMI terminal of the TV, the input channel
may not switch automatically. In this case, use the remote
control for the TV to switch input. (For details on how to
switch input, please read the operating instructions for the
TV.)
≥ Check the VIERA Link setting on the connected device.
≥ Set the setting to control the VIERA Link of the TV to [Off]
once, and the back to [On] again. (Refer to the operating
instructions of the TV for details.)
Problem
Check points