Philips AVCHD HDC-TM20 - Manual (Page 60)

60
VQT2B30
Function Effect/Setting method
Relay recording
It is possible to continuously record motion picture to an SD
card when there is no space available in the built-in memory.
≥ Change the mode to .
Select the menu. (l 27)
[RECORD SETUP] # [RELAY REC] # [ON]
≥ is displayed on the screen. will disappear when space
in the built-in memory is gone and the recording to the SD card
starts.
≥ It allows to record only to SD card from built-in memory.
≥ Relay recording can only be performed once.
≥ Combine the scenes that were relay recorded using the
[RELAY SCENE COMBINE] into the SD card. (l 90)
≥ Once the relay recorded scene and the scene that was recorded
on the SD card after that are combined into the SD card using the
[RELAY SCENE COMBINE], it will be possible to perform the
relay recording again.
≥ If the [RELAY REC] is set to [ON] without performing the [RELAY
SCENE COMBINE], a message is displayed. You will be able to
perform relay recording by touching [YES], but you will not be able
to perform the [RELAY SCENE COMBINE] after that.
Anti-Ground-
Shooting (AGS) If the unit continues to be tilted upside down from the normal
horizontal position while recording motion pictures, it is
automatically put into recording pause.
≥ Change the mode to .
Select the menu. (l 27)
[RECORD SETUP] # [AGS] # [ON]
Auto slow shutter You can record bright pictures even in dark places by slowing
the shutter speed.
≥ Change the mode to .
≥ The intelligent auto mode is set to off. ( l 40)
Select the menu. (l 27)
[RECORD SETUP] # [AUTO SLOW SHTR] # [ON]
≥ The shutter speed is set to 1/25 or more depending on the
surrounding brightness.