Rs-232 communications protocol & command set – Panamax BANKS WIRING MB1000 User Manual
Page 13
11
RS-232 Communications Protocol & Command Set
RESET FACTORY SETTINGS
Resets all of the custom configuration settings
Send to UPS:
!RESET_ALL<CR>
Action:
Sets all state variables to the default
values
Response from UPS:
$FACTORY SETTINGS
RESTORED <CR>
_________________________________________
QUERIES
IDENTIFY
Request that the unit identify itself.
Send Query to UPS:
?ID<CR>
Action:
Model number and firmware revision
will be provided.
Response:
$PANAMAX<CR>
$MB1000<CR>
$FIRMWARE revision<CR>
_________________________________________
OUTLET STATUS
Requests the on/off status of the outlet banks
Send Query to UPS:
?OUTLETSTAT<CR>
status = {ON, OFF}
Action:
On/Off status for outlets
will be provided.
Response:
$BANK1 = status<CR>
$BANK2 = status<CR>
_________________________________________
POWER STATUS
Requests the status of the input voltage. The responses are the
same as Power Fault Status Change.
Send Query to UPS:
?POWERSTAT<CR>
Action:
Power status messages will be
returned
Response:
Normal operation $PWR =
NORMAL<CR>
Overvoltage
$PWR = OVERVOLTAGE<CR>
Undervoltage
$PWR = UNDERVOLTAGE<CR>
Lost Power
$PWR = LOST POWER<CR>
Test Mode
$PWR = TEST<CR>
_________________________________________
VOLTAGE
Requests the input and output voltages
Send Query to UPS:
?POWER<CR>
Action:
Voltage status messages will be
displayed
Response:
$VOLTS_IN = vvv<CR>
$VOLTS_OUT = vvv<CR>
$WATTS = xxxx<CR>
$VA = xxxx<CR>
xxx is expressed in decimal format. If the value is less than 100,
the hundreds digit is represented with a 0. For example a line
voltage of 92VAC would be expressed as: $VOLTAGE =092
_________________________________________
LOAD LEVEL STATUS
Requests the load level, expressed as percentage of maximum.
Send Query to UPS:
?LOADSTAT<CR>
Action:
Load level will be displayed
Response:
$LOAD = xxx<CR>
xxx is the load level (percentage of maximum load) expressed in
decimal format. If the value is less than 100, the hundreds digit
is represented with a 0.
_________________________________________